ZyXEL ADSL Prestige 2602R-61 VoIP 91-006-024004B Manual Do Utilizador

Prestige 2602R Series User’s Guide

332 

Chapter 35 Remote Management

Figure 207   Menu 24.11 Remote Management Control

The following table describes the fields in this menu.

Remote management over LAN or WAN will not work when:

• A filter in menu 3.1 (LAN) or in menu 11.5 (WAN) is applied to block a Telnet, FTP or 

Web service. 

• You have disabled that service in menu 24.11.
• The IP address in the Secured Client IP field (menu 24.11) does not match the client IP 

address.  If it does not match, the Prestige will disconnect the session immediately.

• There is already another remote management session with an equal or higher priority 

running. You may only have one remote management session running at one time.

• There is a firewall rule that blocks it.

Menu 24.11 - Remote Management Control

 TELNET Server:
   Server Port = 23                   Server Access = LAN only
   Secured Client IP = 0.0.0.0
 FTP Server:
   Server Port = 21                   Server Access = LAN only
   Secured Client IP = 0.0.0.0
 Web Server:
   Server Port = 80                   Server Access = LAN only
   Secured Client IP = 0.0.0.0

Press ENTER to Confirm or ESC to Cancel:

Table 111   Menu 24.11 Remote Management Control

Telnet Server

 

FTP Server        

Web Server    

Each of these read-only labels denotes a service or protocol.

Port

This field shows the port number for the service or protocol. You may change the 

port number if needed, but you must use the same port number to access the 

Prestige.

Access

Select the access interface (if any) by pressing the [SPACE BAR]. Choices are: 

LAN only, WAN only, All or Disable. The default is LAN only.

Secured Client IP The default 0.0.0.0 allows any client to use this service or protocol to access the 

Prestige. Enter an IP address to restrict access to a client with a matching IP 

address.

When you have completed this menu, press [ENTER] at the prompt “

Press ENTER to Confirm 

or ESC to Cancel:

”  to save your configuration, or press [ESC] at any time to cancel.