ZyXEL ADSL Prestige 2602R-61 VoIP 91-006-024004B Manual Do Utilizador

Prestige 2602R Series User’s Guide

Chapter 36 IP Policy Routing

339

This section shows you where to apply the IP policies after you design them.

From Menu 3 — Ethernet Setup, type 2 to go to Menu 3.2 — TCP/IP and DHCP Ethernet 
Setup.

You can choose up to four IP policy sets (from 12) by typing their numbers separated by 
commas, for example, 2, 4, 7, 9.

Gateway type

Press [SPACE BAR] and then [ENTER] to select Gateway addr and enter the

 

IP address of the gateway if you want to specify the IP address of the gateway.

 

The gateway must be a router on the same segment as your Prestige's LAN or 

WAN port.
Press [SPACE BAR] and then [ENTER] to select Gateway node to have the

 

Prestige send traffic that matches the policy route through a specific remote 

node.

 

Gateway addr

If you selected Gateway addr in the Gateway type field, defines the outgoing

 

gateway address here.

 

The gateway must be on the same subnet as the 

Prestige if it is on the LAN, otherwise, the gateway must be the IP address of a 

remote node. The default gateway is specified as 0.0.0.0.

Gateway node

If you selected Gateway node in the Gateway type field, enter the index

 

number of 

the remote node you configured in menu 11.

Type of Service

Set the new TOS value of the outgoing packet. Prioritize incoming network traffic 

by choosing No Change, Normal, Min Delay, Max Thruput, Max Reliable or 

Min Cost.

Precedence

Set the new outgoing packet precedence value. Values are 0 to 7 or No 

Change.

Log

Press [SPACE BAR] and then [ENTER] to select Yes to make an entry in the 

system log when a policy is executed.

When you have completed this menu, press [ENTER] at the prompt “

Press ENTER to Confirm 

or ESC to Cancel:

”  to save your configuration, or press [ESC] at any time to cancel.

Table 113   Menu 25.1.1 IP Routing Policy (continued)