SMART Technologies 600i4 Manual Do Utilizador

CHAPTER 2 – ADDITIONAL  DETAILS FOR  INSTALLING YOUR INTERACTIVE 
WHITEBOARD SYSTEM

 

Tips for Adjusting the Projected Image

Refer to these notes when adjusting the projected image as described in the included 

.

•

Project a computer image (set to the proper resolution) while adjusting the image. 
If you don’t have a computer, use the projector’s default background so that you 
can see the full projected image clearly.

•

Don’t use the projector’s on-screen menu options to make image adjustments. 
Instead, use the mechanical adjustments described in the installation document.

•

Don’t loosen the wingnut on the top of the ball joint too much or the projector won’t 
hold the adjustments.

•

As you tilt the projector up or lower its mounting boom to raise the image, the 
entire projected image may increase slightly in size during this process, and more 
at the bottom of the projected image than at the top.

•

Don’t pay attention to the position of the left and right edges relative to your 
interactive whiteboard when you move the projector left or right until both the top 
and bottom edges of the image are horizontal.

•

When you move the projector forward or backward on the boom to make the 
image larger or smaller, you may need to tilt or turn the projector slightly to keep 
the image square.

•

To fine-tune the image, you may need to repeat all steps described in the 
installation document in smaller increments.