SMART Technologies 600i4 Manual Do Utilizador

CHAPTER 3 – USING YOUR INTERACTIVE WHITEBOARD SYSTEM

 

Using Your Remote Control

The SMART UF65 or SMART UF65w projector remote control enables you to access 
on-screen projector menus and change projector settings.

Installing the Remote Control Battery

Follow this procedure to use the remote control for the first time or to replace the 
remote control battery.

WARNINGS
•

Reduce the risk associated with a leaking battery in the projector’s remote 
control by following these practices:

–

Use only the specified coin-cell type battery.

–

Orient the battery’s plus (+) and minus (-) terminals according to the 
markings on the remote control.

–

Remove the battery when the remote control is unused for an extended 
period.

–

Do not heat, disassemble, short or recharge the battery, or expose it to 
fire or high temperatures.

–

Avoid eye and skin contact if the battery has a leak.

•

Dispose of the exhausted battery and product components in accordance with 
applicable regulations.

1. Hold down the side release on the left side 

of the battery holder and pull the battery 
holder completely out of the remote control.

2. Remove the plastic sheet inside the battery 

holder, and then insert a CR2025 coin cell 
battery into the battery holder.

TIP
Make sure that the positive (+) and 
negative (-) signs on the battery 
terminals align with the correct signs 
on the battery holder.

3. Re-insert the battery holder into the remote control.