SMART Technologies 600i4 Manual Do Utilizador
45 |
CHAPTER 4 – REMOTELY MANAGING YOUR INTERACTIVE WHITEBOARD
SYSTEM
SYSTEM
Source Selection Controls
These commands switch input sources. The source type determines which
commands can be accepted.
commands can be accepted.
Source Selection Response Field Description
General Source Controls
The following source controls apply to all input sources. These controls are
unavailable when the projector is off. You can specify custom color values for all
inputs.
unavailable when the projector is off. You can specify custom color values for all
inputs.
Source Information Commands
These commands inform you of the current source settings.
These commands inform you of the current source settings.
Command
Response
Available When
Powered Off
Powered Off
get input
input=[field]
yes
set input [field]
input=[field]
no
Field
Description
VGA1
Switches source to the VGA 1 input connector.
VGA2
Switches source to the VGA 2 input connector.
Composite
Switches source to the Composite video connector. If you
installed your interactive whiteboard system according to
the instructions, this is the relay from the ECP.
installed your interactive whiteboard system according to
the instructions, this is the relay from the ECP.
S-Video
Switches source to the S-Video input connector.
None
A non-selectable value that appears when you enter a “get
input” command while the projector is in Idle mode.
input” command while the projector is in Idle mode.
Command
Response
get displaymode
displaymode=[current display mode setting]
get brightness
brightness=[current brightness setting]
get contrast
contrast=[current contrast setting]
get whitepeaking
whitepeaking=[current whitepeaking setting]
get degamma
degamma=[current degamma setting]
get red
red=[current red color setting]
get green
green=[current green color setting]