ZyXEL Access Point G1000 v2 91-005-124001B Manual Do Utilizador

ZyXEL G-1000 v2 User’s Guide

Chapter 16 Firmware and Configuration File Maintenance

123

The following is an example TFTP command:

TFTP [-i] host get rom-0 config.rom

where “i” specifies binary image transfer mode (use this mode when transferring binary files), 
“host” is the G-1000 v2 IP address, “get” transfers the file source on the G-1000 v2 (rom-0 
name of the configuration file on the G-1000 v2) to the file destination on the computer and 
renames it config.rom.

The following table describes some of the fields that you may see in third party TFTP clients.

Note: The console port is internal and reserved for technician use only.

Back up configuration via console port by following the HyperTerminal procedure shown 
next. Procedures using other serial communications programs should be similar.

1 Display menu 24.5 and enter “y” at the following screen.

2 The following screen indicates that the Xmodem download has started.

Table 54   General Commands for Third Party TFTP Clients

Host

Enter the IP address of the G-1000 v2. 192.168.1.2 is the G-1000 v2’s default 

IP address when shipped.

Send/Fetch

Use “Send” to upload the file to the G-1000 v2 and “Fetch” to back up the file on 

your computer. 

Local File

Enter the path and name of the firmware file (*.bin extension) or configuration 

file (*.rom extension) on your computer.

Remote File

This is the filename on the G-1000 v2. The filename for the firmware is “ras” 

and for the configuration file, is “rom-0”.

Binary

Transfer the file in binary mode.

Abort

Stop transfer of the file.

Ready to backup Configuration via Xmodem.
Do you want to continue (y/n):

You can enter ctrl-x to terminate operation any time.
Starting XMODEM download...