ZyXEL Access Point G1000 v2 91-005-124001B Manual Do Utilizador

ZyXEL G-1000 v2 User’s Guide

Chapter 17 System Maintenance and Information

129

The following table describes the fields in this menu.

Remote management over LAN or WAN will not work when:

1 A filter in menu 3.1 (LAN) or in menu 11.5 (WAN) is applied to block a Telnet, FTP or 

Web service. 

2 You have disabled that service in menu 24.11.

3 The IP address in the Secured Client IP field (menu 24.11) does not match the client IP 

address.  If it does not match, the G-1000 v2 will disconnect the session immediately.

4 There is already another remote management session of the same type (Telnet, FTP or 

Web) running. You may only have one remote management session of the same type 
running at one time.

5 There is a web remote management session running with a Telnet session. A Telnet 

session will be disconnected if you begin a web session; it will not begin if there already 
is a web session.

When NAT is enabled:

• Use the G-1000 v2’s WAN IP address when configuring from the WAN. 
• Use the G-1000 v2’s LAN IP address when configuring from the LAN.

Table 57   Menu 24.11 Remote Management Control

     TELNET Server:     
     FTP Server:        
     Web Server:      
     SNMP Service:      
     DNS Service:

Each of these read-only labels denotes a server or service that you may use to 

remotely manage the G-1000 v2.

Port

This field shows the port number for the remote management service. You may 

change the port number for a service if needed, but you must use the same 

port number to use that service for remote management.

Access

Select the access interface (if any) by pressing the [SPACE BAR]. Choices are: 

LAN only, WAN only, All or Disable. The default is LAN only.

Secured Client IP

The default 0.0.0.0 allows any client to use this service to remotely manage the 

G-1000 v2. Enter an IP address to restrict access to a client with a matching IP 

address.

Once you have filled in this menu, press [ENTER] at the message "Press ENTER to Confirm or ESC to 

Cancel" to save your configuration, or press [ESC] to cancel.