Pelco NSM5200 Manual Do Utilizador

22

C3683M  (3/09)

The NSM5200 supports remote administration from an Endura workstation. The NSM5200 is compatible with the entire family of Endura-ready 
devices using TCP/IP and UPnP protocols. Consult your network administrator before installing the NSM5200 to avoid possible network conflicts.

Use the left Gigabit Ethernet adapter port 

 to connect the NSM5200 to the Endura network. This is required for Endura operation. 

NOTES:  For best results, you should only implement an Endura system on a 1000Base-T network. Unless the Endura installation is very small 
with a dedicated Endura network, a 100Base-T network will not support the necessary data throughput requirements.

To connect the NSM5200 to the Endura network using a switched Gigabit Ethernet network:

Figure 17.  Network Cable Connection

1. Connect one end of the unshielded twisted pair (UTP) cable to the left network connector on the NSM5200 rear panel. Use standard Cat5e 

or better UTP cable with RJ-45 connectors.

2. Connect the other end of the UTP cable to an available port on a Pelco-approved Gigabit Ethernet switch. Contact Pelco Product Support at 

1-800-289-9100 (USA and Canada) or +1-559-292-1981 (international) for a list of approved Gigabit Ethernet switches.

There are two indicators on the network connector on the rear panel. The right indicator glows orange when there is a good connection 
between the NSM5200 and a Gigabit Ethernet switch that is powered up. If the indicator does not glow, check the cable and the switch. 
Disregard the left indicator, which shows network activity.

NSM5200

RESERVED

ENDURA NETWORK

ENDURA NETWORK