Pelco NSM5200 Manual Do Utilizador

C3683M  (3/09)

9

Endura is a network system that requires a continuous amount of bandwidth to transmit true, live video; therefore, always include your network 
administrator when planning and installing Endura components.

You will need the following items:

•

Pelco-approved Endura certification

•

Access to an Endura network that is

–

an active, Gigabit Ethernet network that supports the full Internet Protocol suite,

–

configured with at least one Endura system manager, and

–

configured with at least one Endura workstation

•

For best results, make sure your installation meets the power, environmental, and networking guidelines described in the 

 

Endura Installation Guidelines and Best Practices document.

•

When using one or more network switches on the Endura network, enable autonegotiation on all switches.

•

These network requirements represent the minimum standard for a small Endura-capable security network. Consult the Endura Network 
Design Guide to make sure your network is properly configured. Your system might require additional hardware, software, and network 
resources.

1

NSM5200 Series network video recorder

2

Hard drive packs (6 filled hard drive carriers each)

1

Accessory pack:

5

Rubber feet with 8-32 x 0.375-inch, Phillips pan head screws (for desktop mounting, installed)

2

Power cords either 2 US (North American), 2 European standard, 2 UK standard, 2 Australian, or 2 Argentinian

 

NOTE:  Units shipped to China do not include power cords.

2

Front  bezel  keys

1

Disposable wrist strap for electrostatic discharge (ESD) protection

1

Rack mount kit (included with accessory pack):

2

Chassis mounting brackets with handles and thumbscrews (installed)

12

Screws, 10-32 x 0.25-inch, Phillips pan head (six for each bracket, installed)

2

Adjustable support rail sets (each set includes one front-mounting rail and one rear-mounting rail)

8

Screws, 8-32 x 0.375-inch, Phillips truss head (four for each support rail)

8

Screws, 10-32 x 0.5-inch, Phillips flat head (two for each front rail, two for each rack rail spacer)

4

Screws, 10-32 x 0.75-inch, Phillips pan head (two for each rear rail)

1

Cable management bracket

2

Screws, 6-32 x 0.25-inch, Phillips pan head

2

Rack rail spacers

14

Cage nuts, 10-32

3

Product serial number labels (attached to unit)

1

NSM5200 Series Network Storage Manager Installation manual

1

Web Configuration manual

1

Safety instructions