Sanyo CVW-EXA224 Manual Do Utilizador

 

 

9

3  Unloading and Carpentry Procedures 

 

The SANYO Cases described in this manual are built to meet the requirements of American National Standard/NSF International 
Standard 7. Each SANYO Case bears a nameplate identifying the type of application for which it was certified: 

Type I display refrigerator/freezer: Intended for use in an area where the environmental conditions are controlled and 
maintained so that the ambient temperature typically does not exceed 75°F.

 

As noted above, the SANYO Cases described in this manual are design for the display of products in interior spaces with climate 
control, with ambient conditions typically maintained below 75°F and 55% relative humidity. Proper SANYO Case performance 
cannot be guaranteed when ambient temperature and/or humidity exceed this level. 

SANYO Cases should not be exposed to direct sunlight or other sources of heat. 

SANYO Cases should not be exposed to strong air currents, as these may disrupt the dual air curtains used to maintain proper 
temperature inside the merchandiser display area. 

All SANYO Cases and peripheral equipment should be examined for shipping damage prior to and during offloading. All SANYO 
Cases and peripheral equipment goes through outgoing inspection upon leaving our warehouse, and the carrier assumes 
responsibility for the safe arrival of our merchandisers. 

APPARENT DAMAGE: Any obvious loss or damage should be noted immediately at the time of receipt on the freight bill or express 
receipt and signed by the carrier’s agent. Failure to do so may lead to rejection of the claim by the carrier. 

CONCEALED DAMAGE: If damage that is not apparent during unloading is found after unpacking, retain all packing materials and 
submit a written request to the carrier for inspection within 15 days. 

LOST  ITEMS:  Any  claims  related  to  lost  or  missing  items  must be made to SANYO North America Corporation, Commercial 
Solutions Division within 48 hours of receipt of equipment. 

 

SANYO Cases are heavy and bulky, and require at least two people for unloading, moving, and installation. 

Do not remove the wooden beam from the bottom front edge of each SANYO Case until the cases have been moved into place in 
the store lineup. 

Do not walk on the top of the SANYO Cases. Walking on the top of the SANYO Case may lead to serious injury and/or damage to 
the SANYO Case.   

Do not place anything on the top of the SANYO Case or use the top of any SANYO Case for short- or long-term storage.

 

Recommended Practices for Unloading Merchandisers: 

1.  Use a J-Bar (Johnson Bar) to lift one end of the SANYO Case. 

2.  Insert one or more dollies under the base leg. 

3.  Lift the other side with the J-bar. 

4.  (Optional) Insert one or more dollies. 

5.  Move the SANYO Case out of container. 

6.  Use dollies on both ends of the SANYO Case to move to lineup location after unloading from container.