Honeywell N431X Manual Do Utilizador

6 - 19

When Check Character is set to Validate and Transmit, the engine only 
reads Matrix 2 of 5 bar codes printed with a check character, and will trans-
mit this character at the end of the scanned data.  

Default = No Check 

Character.

If you are encountering errors when reading Matrix 2 of 5 bar codes, you 
may want to adjust the redundancy count.  Redundancy adjusts the num-
ber of times a bar code is decoded before transmission, which may reduce 
the number of errors.  Note that the higher the redundancy count, the lon-
ger it will take to decode the bar code.  To adjust the redundancy, scan the 
Matrix 2 of 5 Redundancy bar code below, then scan a redundancy count 
between 0 and 10 on the 

 inside the back cover of this 

manual.  Then scan the 

 bar code.  

Default = 0.

Scan the bar codes below to change the message length.  Refer to 

 (page 6-2) for additional information.  Mini-

mum and Maximum lengths = 1-80.  Minimum Default = 3, Maximum 
Default = 80.