Festool PI571810 Manual Do Utilizador

6

If an extension cord is required, it must 

have suffi cient cross-section to prevent an 

excessive drop in voltage or overheating. 

An excessive drop in voltage reduces the 

output and can lead to failure of the motor. 

The table below shows you the correct cord 

diameter as a function of the cord length for 

the RO 150 FEQ.

Use only U.L. and CSA listed extension cords. 

Never use two extension cords together. In-

stead, use one long one.

Note: The lower the AWG number, the stron-

ger the cord.

  The tool has full-wave electronics with 

the following features:

Smooth start-up 
The smooth start-up ensures jolt-free start-

up.

Speed adjustment 
You can regulate the speed steplessly between 

3300 and 6800 rpm using the adjusting wheel 

(3.1). This lets you optimize the sanding 

speed to suit the material.

Constant speed 
The pre-selected speed remains constant 

whether the tool is in operation or in neutral 

position.

Temperature control 
To prevent overheating, the safety electronics 

switch the tool off when it reaches a critical 

motor temperature. Let the tool cool down 

for approx. 3-5 minutes before using it again. 

The tool requires less time to cool down if it 

is running, i.e. in neutral position.

Total Extension Cord 

Lenght (feed)

25

50

100 150

Cord size (AWG)

18

16

16

14