Delta 36-5000 Manual Do Utilizador

31

1.  Move fence adjacent to right miter gauge and 

secure to the guide tube by lowering the fence 

clamping lever.

2.   If the fence face (A) figure 39, is not parallel to the 

miter slot (B), raise the clamping lever and lift the 

fence and place it on the saw table.

3.  Adjust the one or both of the set screws (C) 1/4 

turn or less.

4.  Replace fence on guide tube and repeat steps 1 

through 3. If fence is closer to parallel, turn the set 

screw in the same direction but a little less. If the 

fence is further out of parallel, turn the set screw in 

the opposite direction.

5.   Repeat steps 1 through 3.

1.  Move fence over the cast iron table and secure 

to the guide tube by lowering the fence clamping 

lever.

2.  Use a square to check that the fence face is 

perpendicular to the table.

3.  If the fence face is not perpendicular to the table, 

release the clamping lever and slightly adjust one 

of the slotted set screws (A) figure 40 until the 

fence face is perpendicular to the table.

4.  Secure the fence to the guide tube to insure the 

fence remains perpendicular. If not, repeat steps 1 

through 4.

The 120/240 volt, dual-voltage motor supplied with your machine was shipped prepared for 120 volt operation. 

It can be converted for 240 volt operation. For conversion from 120 volt to 240 volt, please call ahead to DELTA 

Customer Care at 1-800-223-7278.