Graco Inc. 257096 Manual Do Utilizador

Follow this Pressure Relief Procedure whenever 
instructed to relieve pressure, stop spraying, check or 
service equipment, or install or clean spray tip.

1.

Turn OFF power and turn sprayer pressure control to 
lowest pressure setting.

2.

Hold gun against side of grounded metal flushing pail. 
Trigger gun into pail to relieve pressure.

If you suspect spray tip or hose is clogged or that 
pressure has not been fully relieved after following the 
steps above, VERY SLOWLY loosen tip guard retaining 
nut or hose end coupling to relieve pressure gradually, 
then loosen completely. Clear hose or tip obstruction.

To prevent injury when gun is not in use, always set gun 
trigger lock (A) if sprayer is turned off or left unattended.

Make sure sprayer is turned off and unplugged from 
power source. Refer to your sprayer instruction manual 
for priming and spray instructions. 

1.

Attach air hose.

NOTE: The first time you set 
up the gun for spraying you 
will have to cut the black air 
hose to length desired. 

2.

Attach fluid hose.

3.

See Setup instructions in 
sprayer operation manual 
(313316).

Trigger lock

Air on/off valve

Spray Tip

Air hose connection

Safety RAC guard

Air adjustment valve

Trigger

Fluid hose connection

ti12849a

(A)

(B)

ti10352a

ti10353a

ti13318a

ti13317a