Graco 16H245 Manual Do Utilizador
Setup
12
3A1698F
Sprayer Setup
This sprayer arrives from the factory with a small
amount of test material in the system. It is important
that you flush this material from the sprayer before
using it for the first time:
amount of test material in the system. It is important
that you flush this material from the sprayer before
using it for the first time:
1.
Fill material cup with water or compatible solvent,
thread onto sprayer and hand tighten.
thread onto sprayer and hand tighten.
2.
Put prime/pressure relief valve to UP position, then
hold trigger in for 10 seconds.
hold trigger in for 10 seconds.
3.
Put prime/pressure relief valve DOWN to spray
position.
position.
4.
Reverse spray tip to UNCLOG position and trigger
sprayer into a waste area for 10 seconds.
sprayer into a waste area for 10 seconds.
5.
Engage trigger lock and put prime/pressure relief
valve UP to release pressure.
valve UP to release pressure.
6.
Unscrew and remove material cup.
7.
Disengage trigger lock, put prime/pressure relief
valve DOWN, hold sprayer slightly above material
cup, and pull trigger to discharge fluid from pump.
valve DOWN, hold sprayer slightly above material
cup, and pull trigger to discharge fluid from pump.
8.
Put prime/pressure relief valve UP and pull trigger to
finish material flushing.
finish material flushing.
9.
Discard material in cup.
ti14992a
ti16712a
ti14999a
ti16700a
ti15425a
ti16701a
ti15491
ti16713a
ti14991a
ti14999a
ti14994a
ti16699a
ti16700a
ti15478a
ti16714a