Graco 16W883 Manual Do Utilizador

E=XX is displayed

Fault condition exists.

Determine fault correction from table, page 31.

Engine will not start

Engine switch is OFF.

Turn engine switch ON.

Engine is out of gasoline.

Refill gas tank. Honda Engine Manual.

Engine oil level is low.

Try to start engine. Replenish oil, if necessary. 
Honda Engine Manual.

Spark plug disconnected or damaged.

Connect spark plug cable or replace spark 
plug.

Engine is cold.

Use choke.

Fuel shutoff lever is OFF.

Move lever to ON position.

Oil is seeping into combustion cham-
ber.

Remove spark plug. Pull starter 3 to 4 times. 
Clean or replace spark plug. Start engine. 
Keep sprayer upright to avoid oil seepage.

False tripping of WatchDog system. 
EMPTY is displayed. Pump does not 
run.

Operating conditions out of WatchDog 
parameters.

Pump output is low, page 23.

Turn pressure down. Contact Graco Technical 
Assistance to adjust WatchDog parameters. 
Operate without WatchDog active (see Opera-
tion manual).

Engine operates, but displacement 
pump does not operate

Error code displayed.

See 

Digital Display Messages, page 31.

Pump switch is OFF.

Turn pump switch ON.

Pressure setting too low.

Turn pressure adjusting knob clockwise to 
increase pressure.

Fluid filter is dirty.

Clean filter.

Tip or tip filter is clogged.

Clean tip or tip filter (see gun manual).

Displacement pump piston rod is stuck 
due to dried paint.

Repair pump (see pump manual).

Connecting rod is worn or damaged.

See Parts manual.

Drive housing is worn or damaged.

See Parts manual.

Electrical power is not energizing clutch 
field.

See Parts manual.

See 

Digital Display Messages, page 31.

With pump switch ON and pressure turned to 
MAXIMUM, use a test light to check for power 
between clutch test points on control board.

Remove clutch wires from control board and 
measure resistance across clutch coil. At 70° 
F, the resistance must be between for 3900 - 
1.2 + 0.2 

Ω, for 5900/7900 1.7 ± 0.2 Ω; if not, 

replace pinion housing.

Have pressure control checked by authorized 
Graco dealer.

Clutch is worn, damaged, or incorrectly 
positioned.

Adjust or replace clutch. See page 32.

Pinion assembly is worn or damaged.

Repair or replace pinion assembly. Page 32.