Echo SHC-225 Manual Do Utilizador

Hedge Clipper blades are very sharp.  Touching them may lead to 

severe personal injury.  Avoid touching blades whenever possible, 

and always wear gloves to protect hands. 

The blade cover is used for transportation and storage. Remove 

blade cover before using the unit.

The attachment will operate immediately when the engine starts 

and could result in loss of control and possible serious injury. 

Keep movable parts of the attachment off the ground and away 

from objects that could become entangled or thrown.

1.  Stop Switch

Move Stop Switch button away from the STOP position.

2.  Choke

 

Move choke (B) to Cold Start (

) position.

3.  Purge Bulb

 

Pump purge bulb (C) until fuel is visible and flows freely in the 

clear fuel tank return line. Pump bulb an additional 4 or 5 times.

4.  Recoil Starter

 

Lay the unit on a flat area and keep movable attachment parts clear 

of all obstacles. Firmly grasp throttle handle and throttle trigger 

lockout with left hand and fully depress throttle trigger to wide 

open position. Rapidly pull recoil starter handle/rope (D) until 

engine fires (or maximum five [5] pulls).

5.  Choke

 

After engine fires or five (5) pulls, move choke lever back to Run 
(

) position. Firmly grasp throttle handle and throttle trigger 

lockout with left hand and fully depress throttle trigger to wide 

open position. Pull starter handle/rope until engine starts and runs. 

Release throttle trigger and allow unit to warm up at idle for several 

minutes.

If engine does not start with choke in Run position after 5 pulls, 

repeat instructions 2 -5.