Yard Machines 41AD-280G000 Manual Do Utilizador

6. Take approximately 25 feet (7.6 m) of new trim-

ming line, loop it into two equal lengths. Insert
each end of the line through one of the two holes
in the inner reel. Pull the line through the inner reel
so that the loop is as small as possible. See
Figure 22.

7. Wind the lines in tight even layers, onto the reel.

Wind the line in the direction indicated on the
inner reel. Place your index finger between the
two lines to stop the lines from overlapping. Do
not overlap the ends of the line. See Figure 23.
Proceed to step 11.

8.

Take approximately 12 feet (3.65 m) of new trim-
ming line. Insert one end of the line through one
of the two holes in the inner reel. Pull the line
through the inner reel until only about 4 inches is
left out. See Figure 24.

9.

Insert the end of the line into the open hole in the
inner reel and pull the line tight to make the loop
as small as possible, See Figure 24.

10. Before winding, split the line back about 6 inches.

11. Wind the line in tight even layers in the direction

indicated on the inner reel.

NOTE: Failure to wind the line in the direction indi-
cated will cause the cutting attachment to operate
incorrectly.