Zenoah HT2200 Manual Do Utilizador

■ STARTING ENGINE

1. When first starting up after putting fuel into the

machine, push the priming pump until fuel runs out
in the clear tube. Then close the choke. Choking
may not be necessary when re-starting right after
stopping the engine. (OP1)

2. Pull the throttle lever and push the lock button to set

the lever in the START position. (OP2)

3. Slide the ignition switch to the engine side to set it in

the ON position. (OP3)

4. Rest the unit on a firm place. Pull the starter knob

quickly. (OP4)

• Avoid pulling the rope to its end or returning it by

releasing the knob. Such actions can cause starter
failures.

5. When the engine has started, gradually open the

choke.

6. Allow the engine to warm up for a half minute before

starting operation.

• If the engine won't start after several attempts, open

the choke and repeat pulling the rope or remove the
spark plug and dry it.