Hitachi CG 22EAB(SL) Manual Do Utilizador

8

○  Do not start or operate unit unless each guard is properly 

assembled to unit.

○  lf unit is operated without a sharp line limiters, the line will 

become too long, the engine will overheat, and engine damage 

may occur.

○  Check sharp line limiters surely cut nylon line when operating.

 

The guard bracket may come already mounted to the gear case 

on some models.

Install the blade guard on drive shaft tube against angle 

transmission. Tighten the guard bracket fi rmly so that the blade 

guard does not swing or move down during operation.

Install the blade guard to the guard bracket, which also secures the 

guard to the gear case using the two guard mounting screws.

         

Only CG22EAB(SL)

 

Some blade guards are equipped with sharp line limiters. Be 

careful with handling it.

When using a trimmer head with two piece type blade guard, attach 

the guard extension to the blade guard. (Fig. 11)

○  When attaching the guard extension to the blade guard, the 

sharp line limiter must be removed from the blade guard, (if so 

installed).

○  If your unit has guard location label on drive shaft tube, follow 

the indication.

○  To remove the guard extension, refer to the drawings. Wear 

gloves as the extension has a sharp line limiter, then push the 

four square tabs on the guard one by one in order. (Fig. 12)

1. Function

 

Automatically feeds more nylon cutting line when it is tapped at 

low rpm (not greater than 4500 rpm).

Code No. Type of 

attaching screw

Direction of 

rotation

Size of 

attaching screw

6696454 Female screw

Counterclockwise M10×P1.25-LH

6696597 Female screw

Clockwise

M8×P1.25-RH

Applicable nylon cord  

 Cord 

diameter: 

Φ3.0 mm   Length: 2 m

 Cord 

diameter: 

Φ2.4 mm   Length: 4 m

000Book_CG22EAS_Eng.indb   8

000Book_CG22EAS_Eng.indb   8

2012/07/16   15:22:40

2012/07/16   15:22:40