Husqvarna 80792 Manual Do Utilizador

14

NOTE: Operating with trimmer line of
uneven length will cause excessive
vibration. Always make sure the line is
wound evenly and trimmed to equal
lengths from the eyelets.

Shipped with
21 feet of .080 line.
Maximum fill–

33 feet of .080
16 feet of .095
14 feet of .105

UN32-7L
UN32-8L
UN32-10L
Shipped with
18 feet of .080 line.
Maximum fill–

40 feet of .080
28 feet of .095
26 feet of .105

INSTALLATION INSTRUCTIONS

UN32-7L
Fits LT18, T18, T20, C20, LT20, T230,
C230, 22T
UN32-8L
Fits F20, T25, C25, T27, C27, BP35,
TC250, T270, C270, T260, C260
UN32-10L
Fits C35, C350, RC45, B45, B450

Depress the tab on the lower housing
and twist the cover counterclockwise
(clockwise on UN34-8R) to align
arrows. Remove the cover and button.

Remove the spool and spring (the
spring is located under the spool).

Clean the spool, housing and eyelets.
Inspect for wear and damage.
Replace damaged components.

Inspect the arbor bolt and replace it if
damaged. Re-attach the eyelets if
they were removed or replaced.
Never operate a trimmer head
without eyelets!

Replace the line by threading it
through the eyelet in the spool until
line lengths are equal. Refer to the
Line Chart (above) for the proper
amount of line.

With line saver slots facing you,
wind the line clockwise in the spool
using a finger to keep the two lines
separate (UN34-8R: Wind the line
counterclockwise).

UN34-7L
Fits LT18, T18, LT20, T20, C20, T230,
C230, 22T
UN34-8R
Fits F18, F21, F230, 22F