Heath Zenith UT-5681-BZ Manual Do Utilizador

2

This fi xture can be directly wall mounted or wall mounted using a 
weatherproof junction box. Use the instructions below that apply 
to your application.

1.  Select a location on a fl at wall with structurally sound wood 

and from 5 to 25 feet (1.5 to 7.6 m) from the ground. The wood 
should be at least one inch (25 mm) thick to safely secure the 
fi xture.

2.  Using the mounting template as a guide, mark the 3 mounting 

holes. We suggest drilling 3/16" (4.8 mm) pilot holes for the 
lag screws.

3.  Install the two bottom lag screws fi rst. Screw in the lag screws 

so that there is about 3/8" (9.5 mm) of space under the head.

4.  Apply silicone caulk around threaded hole on rear of fi xture.
5.  Place the fi xture on these two screws and install the top lag screw. 

Tighten the top lag screw fi rst, then tighten the remaining lag 
screws.

6.  Remove the two screws attaching the fi xture cover plate to the 

fi xture (see Figure 2).

7.  Route the service wires from the conduit through the fi xture 

cover plate (see Figure 2).

8.  Secure your outdoor cable or fl exible conduit to the cover plate 

with a fi tting (not supplied) in accordance with the National 
Electrical Code (Canadian Electrical Code in Canada).

1.  Thread 1/2" NPT coupler (supplied) into the threaded hole on 

the rear of the fi xture.

2.  Attach junction box cover plate with 1/2" NPT threads (not 

supplied) to coupler.

3.  Verify the mounting holes on the cover plate are correctly aligned 

with the mounting holes on the junction box and install the 1/2" 
NPT nut behind the cover plate. Securely tighten nut against 
back of cover plate.

4.  Caulk between coupler and cover plate.
5.  Remove the two screws attaching the fi xture cover plate to the 

fi xture.

6.  Route service wires through coupler and into the fi xture.
7.  Securely attach the cover plate to the junction box.

 CAUTION: Do not use any other wattage lamps 

To test operation during daylight, cover the photocontrol (round 
object on front of fi xture) with black electrical tape. Turn on the 
power. The light should come on immediately and will take a few 
minutes to reach full brightness. Uncover the photocontrol and your 
unit will operate automatically—on at dusk, off at dawn.

1.  Connect the fi xture wires to the service wires as shown in Figure 

2 (black to black and white to white).

2. This 

fi xture must be connected to ground. Secure the service 

ground wire under the head of the green ground screw (see 
Figure 2).

3.  Install the cover plate. Secure with the two screws provided (see 

Figure 2).

4.  Plug in the 42 watt compact fl uorescent lamp provided (NEMA 

designation CFTR42W/GX24Q with GX24Q-4 base).

 

ATTENTION: When removing, grasp bulb by the base. Do not 
grasp glass bulb to remove.

Cover Plate

Caulk

Ground 

Screw

Bulb

Lag Screw

 WARNING: Turn power off at the circuit breaker