Heath Zenith SL-5680 Manual Do Utilizador

© 2007 HeathCo LLC 

598-1100-02

Mounting Plate

Ground 

Screw

(A)

(B)

Fluorescent 

Lamp

Lens

1.  Select a location on a flat wall with a properly attached electrical

junction box.

2.  Unscrew the lens. Set aside the lens and fluorescent lamp.
3.  Remove the decorative nut. Remove the mounting plate.
4.  Thread the junction box wires through hole (A) in the mounting

plate.

5.  Make sure the arrow on the mounting plate is pointed up. See

which pair of holes in the mounting plate will line up for your
junction box. Secure the mounting plate to the junction box. The
two #8-32 screws provided should work with round or octagon
junction boxes. If you are using a small rectangular box, you
will need to purchase two #6-32 screws at least 1/2" long.

6.  Secure  the  service  ground  wire  under  the  head  of  the  green

ground screw.

7.  Connect the fixture wires to the service wires (

black to black

and white to white). Secure with wire nuts provided.

8.  Make sure the wire nuts and wires are inside the fixture wiring

compartment.  Secure  the  fixture  body  to  the  mounting  plate
with decorative nut (B).

9.  Plug in the 13 Watt fluorescent lamp provided.
10. Reinstall the Lens.
11. Caulk fixture mounting surface with silicone weather sealant.
To test operation during daylight, cover the photocontrol window
with black tape. Turn on the power. The photocontrol has a time
delay (up to 2 minutes) before it will respond to light changes. The
light will take up to five minutes to reach full brightness. Uncover
the photocontrol and your unit will operate automatically—on at
dusk, off at dawn.

Photocontrol

NOTE:  All wiring must be run in accordance with the National Electrical Code (Canadian Electrical Code in Canada) through 

conduit or another acceptable means. Contact a qualified electrician if there is any question as to the suitability of 
the system.