Wagner SprayTech HT3500 Manual Do Utilizador

English

4 

This heat gun produces extremely high temperatures (as high as 1450° F).  It must be 

used with caution to prevent combustible material from igniting.

  1.  Keep the gun in constant motion.  Do not stop or dwell in one spot.

Facia
Soffit

Inside

Wall

Siding

  2.  Use extreme caution if the other side of the 

material being scraped is inaccessible, such 

as house siding.  The hidden side could catch 

on fire if it becomes too hot.  Some buildings 

contain highly flammable materials behind 

siding, floors, facia, soffit boards and other 

panels.  Check these areas before applying 

heat and do not use a heat tool if flammable 

materials are present or if you are unsure of the 

hidden material.

  3.  Do not use near surfaces with cracks or near metal pipes or flashing.  Heat may 

be conducted behind the work surface and ignite hidden material.  The ignition of 

hidden materials may not be readily apparent and can result in property damage 

and injury.

  4.  Do not use electric tools in the presence of flammable liquids or gases.

  5.  Do not use near combustible materials such as dry grass, leaves, and paper which 

can scorch and catch fire.

  6.  The nozzle becomes very hot.  Do not lay the heat gun on flammable surfaces 

when operating the gun or immediately after shutting the gun off.  Always set the 

gun on a flat, level surface so that the nozzle tip is directed upwards and away from 

the supporting surface.

  7.  Do not touch the nozzle until the tool has cooled.

  8.  Do not use the heat gun as a hair dryer.

  9.  Tools and paint scrapings become very hot.  To avoid burns, use work gloves when 

scraping.

  10.  Always treat the hot air units with the same respect as an open flame.
HazaRD:  eLeCTRIC

May cause property damage, severe injury or loss of life.

  1.  Do not disassemble the heat gun.

  2.  Do not work in wet areas or expose the heat gun to rain.

  3.  Guard against electric shock by preventing body contact with grounded surfaces 

such as pipes, radiators, ranges, aluminum ladders or other grounded devices.

  4.  Do not abuse the electric cord.  Never carry the heat gun by the cord or yank on the 

cord to disconnect if from the power supply.  Keep the electric cord away from heat, 

oil and sharp edges.  Inspect the cord for wear or damage regularly.

  5.  Use only extension cords rated for outdoor use.  If an extension cord is damaged or 

otherwise unsuitable for use, replace it with a new cord.

May cause property damage or severe injury.

  1.  Disconnect the heat gun from the power supply when not in use.  Store indoors in a 

dry place and out of the reach of children.

  2.  Keep your work area well lighted and clean.

  3.  Do not overreach, especially when working on ladders.  Keep proper footing and 

balance at all times.  Be certain any ladders being used are sturdy, stable, on a firm