Smeg SE2631ID1 Manual Do Utilizador

 

 

 

 

Hob type 

See rating plate 

 Electrical 

connections 

220-240V~ 50/60Hz / 380-415V 2N

∼ 50/60Hz / 380-415V 3N∼ 50/60Hz 

 

I 

 

Maximum electrical power 

See rating plate 

 

Make sure that the voltage and capacity of the power 
line conform to the data shown on the plate located 
under the casing. Do not remove this plate for any 
reason. 

 

 

 

 

 

 

 

 

 

THE APPLIANCE MUST BE CONNECTED TO EARTH IN COMPLIANCE WITH ELECTRICAL 
SYSTEM SAFETY REGULATIONS.

 

WHEN LINKING UP TO MAINS BY PLUG AND SOCKET, MAKE SURE THAT BOTH ARE 
COMPATIBLE AND CONNECT BY MEANS OF A POWER CABLE COMPLYING WITH APPLICABLE 
REGULATIONS.  

 

THE SOCKET MUST BE ACCESSIBLE AFTER THE APPLIANCE IS BUILT IN. 
NEVER UNPLUG BY PULLING ON THE CABLE.

IMMEDIATELY AFTER INSTALLATION CARRY OUT A BRIEF INSPECTION TEST OF THE HOB, 
FOLLOWING THE INSTRUCTIONS. IF THE HOB FAILS TO OPERATE, AFTER CHECKING THAT 
YOU HAVE CARRIED OUT THE INSTRUCTIONS CORRECTLY, DISCONNECT THE APPLIANCE 
FROM THE ELECTRICAL MAINS AND CONTACT YOUR NEAREST SERVICE CENTRE. 

 

N VER ATTEMPT TO REPAIR THE APPLIANCE.

PASS THE POWER SUPPLY CABLE THROUGH THE BACK OF THE UNIT, TAKING CARE THAT IT 
DOES NOT TOUCH THE BOTTOM CASING OF THE HOB OR THE OVEN (IF ANY) INSTALLED 
UNDERNEATH IT. 

 

IF A PLUG AND SOCKET CONNECTION IS BEING USED MAKE SURE THAT THE PLUG AND 
SOCKET ARE COMPATIBLE. AVOID USE OF ADAPTERS AND SHUNTS AS THESE COULD 
CAUSE OVERHEATING AND RISK OF BURNS.

 

IF A FIXED CONNECTION IS BEING USED FIT POWER LINE WITH AN OMNIPOLAR CIRCUIT 
BREAKER WITH A CONTACT OPENING GAP EQUAL TO OR GREATER THAN 3 MM, IN AN 
EASILY ACCESSIBLE POSITION IN PROXIMITY TO THE OVEN.