Dekko 36BX Manual Do Utilizador

Rev: 8/2008 

 

8 of 21 

36B, 36BX, 36H, 36HX, 52H, 52HX 

DEK

® 

is exclusively distributed by GXi International, LLC 

 

1)  Attach handle bars using the upper hole position 
setting if you are walking behind the mower (not using a 
ride-on Sulky).  By using this hole position, the handle 
bars are several inches lower.  Use the lower hole posi-
tion if you are planning on using a ride-along sulky, rais-
ing the handle bar location by several inches.  These 
hole positions can also be used for adjusting the handle 
bar location for operators with different heights and arm 
lengths.  Select the height that is most comfortable for 
you. 
 
 
 
 
 
 
2)  Reconnect the 4 connecting rods from the control 
panel to the chassis pivot points as per the attached pic-
tures.  The rod connections are secured with an initial 
preset for the upper hole position (lower handle bar posi-
tion).  If the lower hole position (upper handle bar posi-
tion) is used the rod connections must be adjusted. 
 
 
 
3)  Retighten the pivot bolts on the triangular plates on 
each side of the gas tank support bracket (2 locations, 
one on each side of the mower).  
 
 
 
 
 
 
 
 
4)  Should the pivot ends on the connecting rods be ro-
tated during assembly, minor adjustments may be re-
quired to achieve full travel on each control handle. The 
control handles located directly on top of the handle bars 
should have full travel forward and stop approximately 
1/8” before the “V plate” strikes the handle bar. This will 
provide full forward speed and the correct restricted 
speed in reverse.  Please make any minor adjustments 
to the position of the threaded connecting rod attachment