Mr. Coffee ECM11 Manual Do Utilizador
17.
WARNING: To reduce the risk of fire or electric shock, do not remove
any service covers. No user serviceable parts Inside. Repair should
any service covers. No user serviceable parts Inside. Repair should
be done by authorized personnel only.
SPECIAL CORD SET INSTRUCTIONS
1.
A short power supply cord is provided to reduce the hazards resulting
from becoming entangled In or tripping over a longer cord.
from becoming entangled In or tripping over a longer cord.
2.
An extension cord may be purchased and used lf care Is exercised In
Its use.
Its use.
3.
If an extension cord i s used, the marked e
lectrical rating of the exten-
sion cord must be at feast 15 amps and 120 volts. The resulting
extended cord must be arranged so that it will not drape over the
counter top or table top where it can be pulled on by children or
trlpped over accidentally.
Note:
This appliance
has a polarized plug (one blade Is larger than the
other). As a safety feature, this plug will fit In a polarlzed outlet
only one way. If the plug does not fully fit In the outlet, reverse
the plug. If It still does not fit, contact a qualified electrician. Do
the plug. If It still does not fit, contact a qualified electrician. Do
not attempt to defeat thls safety feature.
CAUTION:PRESSURE
In order to avoid possible bu
rns to bodily parts and/or other Injury from
hot steam, etc. NEVER open the boiler cap or remove the filter holder
while this product
while this product
is turned on or as long as there is pressure in the.
water tank.
In order to check If the machine is under pressure, proceed as follows:
Turn the selector control knob counter clockwise, or away from you
and unplug the machlne.
2. Open the steam nozzle by SLOWLY turnlng the selector control
knob counter clockwise, or away from you. If steam comes out of
the nozzle, then the water tank Is still under pressure. Close the
the nozzle, then the water tank Is still under pressure. Close the
steam control knob.
3. To release the pressure, hold a p
itcher with some water under the
steam nozzle and Immerse the nozzle in the water. SLOWLY open
the steam control knob and release the steam.
the steam control knob and release the steam.
4. When steam nozzle stops releasing steam, the boiler cap can be
removed.
5. Close the selector control knob by turn
ing It clockwise, or towards
you.
Use extreme caution when disposing hot steam,