NewAir AK-200 Manual Do Utilizador

CO can be dangerous! CO cylinders contain high-pressured gas, which can be 

2

2

hazardous if handled improperly. They must be handled with care.

Make sure the black pull handle of the tap is in the closed (up) position before 
installing it on the keg (Fig. 1 below). Insert the keg coupler into the locking 
neck of the beer keg and turn clockwise ¼ to lock it into position (Fig. 2 below). 
This means that it is secured to the keg.

When connecting the beer line, it is very important that the black rubber washer 
be installed inside the wing nut before connecting the beer line to the tap (see 
Illustration A  below).  Remove  the  black  rubber  protective cap  located  on  top  of 
tap and screw the wing nut with the rubber washer. Tighten it firmly by hand. 
(Fig.2 below)

Attach the CO  line end of the tube to the hose connection on the tap. Next, 
secure  the  tube  by  using  the  remaining  self-locking  plastic  snap-on  clamp  to 
ensure that there are no leaks. Secure the clamp tightly with pliers (Fig. 3  
below).

Make sure the beer tower faucet is in the closed (handle pointing straight back) 
position before connecting the tap to the keg. To secure the tank connection, pull 
the tapping handle out and push down until it locks into position. Listen for the 
“click”  of  the  pull  handle  when  it  shifts  into  the  final  downward  position  (Fig.  4-
below).This will open the beer and CO  gas valves. The keg is now tapped.

Carefully tilt the keg and

rest the

edge on

the  keg  floor  support  on  the 

bottom  of  the  interior  cabinet.  Slide  the  beer  keg  slowly,  ensuring  that  it  is 
properly located (Fig. 5 below) and carefully close the door.

Your kegerator comes with a 2.5 lb. CO  bottle, which should be able to 
dispense four 15 gallon kegs of beer.

1.

2.

3.

4.

5.

6.

8

2

2

2