GE Monogram ZDBR240PBS Folheto

Página de 2
ZDBR240PBS –  GE Monogram Beverage Center with Digital Controls
Dimensions and Specifications (in inches)
Installation Space
The Monogram
®
 Beverage Center may be installed beneath a  
countertop or can be used free-standing.
•  If installing between frameless cabinets, a 1/2"-wide filler strip 
or side panel may be required. The filler strip will act as a spacer 
between the door case and adjacent cabinet and will prevent  
interference with cabinet door swing. The width of the opening  
must include filler panels.
Note: When installed, the door should project forward 1" of  
adjacent 24"-deep cabinets.
Location Requirements
All Monogram Refrigeration Modules may be closed in on the top  
and sides as long as the front is unobstructed for air circulation and 
door swing.
•  Do not install these products where the temperatures will go  
below 55°F (13°C) or above 90°F (32°C).
•  Do not install where they will be subject to direct sunlight,  
heat or moisture.
• These products are not designed to be stacked one over the other.
For answers to your Monogram,
®
 GE Profile
 or  
GE
®
 appliance questions, visit our website at  
GEAppliances.com or call GE Answer Center
®
  
service, 800.626.2000.
Listed by 
Underwriters 
Laboratories
34-1/2"-35"
24" Min.
23-3/4" 
25-1/2"
Including
Handle
23-3/4"
1-1/2" 
Locate Outlet 
9"  
Max.
10-1/2" 
23-3/4" Min. 
34-1/4"
to
34-3/4"
Specification Revised 12/06
120038
Side-by-Side Installation
For a complete refreshment center, install a Monogram Wine Reserve 
and Beverage Center together.
•  Products must operate from separate properly grounded  
receptacles.
Door Swing Clearances
All Monogram Refrigeration Modules are factory set for a 110°  
door swing.
When installed in a corner:
• Allow the minimum door swing clearances shown.
•  The minimum clearance shown at 90° will allow full extension  
of drawers and shelves.
A
Minimum to Wall  
110
°
110
° Door  
Swing
21-5/8"
23-5/8"
B
Minimum to Wall
90
°
90
° Door  
Swing
10"
Minimum to Wall
4"
Minimum to Wall
Electrical
A 120V, 60Hz, 15 or 20 amp power supply is required. An individual 
properly grounded branch circuit or circuit breaker is recommended. 
Install a properly grounded 3-prong electrical recessed into the  
back wall as shown. Electrical must be located on rear wall as shown.
Note: GFCI (ground fault circuit interrupter) is not recommended.