Roper RUD3000 Manual Do Utilizador

You can cancel a cycle at any time.

1. Turn the Cycle Control knob slowly clockwise until you hear 

water draining. Let the dishwasher drain completely.

2. Open the door.

3. Turn the Cycle Control knob to OFF.

If your dishwasher has more than one wash cycle, you can 
change a cycle anytime during a cycle.

1. Lift the door latch to stop the cycle.

2. Turn the Cycle Control knob clockwise.

3. Check the detergent dispensers. They must be filled properly 

for the new cycle.

NOTE: Turning the Cycle Control knob can cause the covered 
Detergent Dispenser section to open and release the 
detergent. Check the covered section if the cycle uses 
detergent in both sections.

4. Close the door firmly until it latches. The dishwasher starts a 

new cycle.

You can add an item anytime before the main wash starts, or the 
Cycle Control knob reaches Light Wash. 

1. Lift up the door latch to stop the cycle. Wait for the spraying 

action to stop before opening the door.

2. Open the door and add the item.

3. Close the door, but do not latch it. Wait 30 seconds for the air 

in the dishwasher to warm up. This reduces the amount of 
moisture escaping from the vent when restarting a cycle.

4. Close the door firmly until it latches. The dishwasher resumes 

the cycle.

You can change an option anytime before the selected option 
begins. For example, you can press an unheated drying option 
any time before drying begins.

Select this option to dry dishes without heat and save energy. 
The dishes take longer to dry and some spotting can occur.

For best drying, use a liquid rinse aid. Some items (such as 
plastics) may need towel drying. 

NOTE: Energy Saver Dry is an option with all cycles except Rinse 
& Hold (on some models).

Select this option to dry dishes with heated air. For best drying 
results, use a liquid rinse aid and heated drying.

NOTE: Heated Dry is an option with all cycles except Rinse & 
Hold (on some models). 

For Model 5750: To select Heated Dry, press RESET OPTIONS.

Select this low energy washing option to reduce water 
temperature during the main wash and final rinse. This will reduce 
the amount of electricity needed to run the dishwasher.

NOTE: Low Energy Washing (model 5750 only) is an option 
with all cycles.

Select this option to change an option setting.

You can change option settings anytime during a cycle as long as 
the cycle has not passed the point where the option is used. For 
example, you can press Energy Saver Dry anytime before the 
Cycle Control knob reaches Dry.

1. Press RESET OPTIONS.

2. Press 1 or more options.

    

●

●

●

●

●

●

●

●

●

●

●

●

●

●

●

●

●

●

●

●

    

●

●

●

●

●

●

●

●

Use this cycle for pre-
rinsed or lightly soiled 
loads.

Use this cycle for rinsing 
dishes, glasses, and 
silverware that will not be 
washed right away.