Vulcan-Hart 1G8BD ML-136649 Manual Do Utilizador
GBD_GBDF SERIES GAS FRYERS
VULCAN-HART F-32934 Rev. B (June 2008)
-23-
Quick Start Guide for Solid State Knob Controls with KleenScreen PLUS® Filtration:
Filtering in 6 Easy Steps:
Step 1:
Make sure that the power is on. Do NOT turn
off the power to the fryer.
off the power to the fryer.
Step 2:
Open the drain valve slowly allowing the oil to
drain down into the filter pan. The burners will
automatically turn off.
drain down into the filter pan. The burners will
automatically turn off.
Step 3:
Press
FILTER
switch
to
engage
the
motor
/
pump.
Allow
the
oil
to
cycle for a few minutes until the oil
and
fryer
are
clean.
TIP: Use the provided tank
brush to clean and remove food particles from the fry
tank.
Step 4:
Close the drain valve slowly allowing the
oil
to
Drain
Valve
fill the fry tank with clean oil. The burners will
not turn on at this point. Allow the oil to fill back
into the fry tank from the filter pan. It is normal to
see a few air bubbles during this process.
not turn on at this point. Allow the oil to fill back
into the fry tank from the filter pan. It is normal to
see a few air bubbles during this process.
Step 5:
When
the
filter
pan
is empty push the FILTER switch
to turn off the motor / pump. Oil level should be
between
the
MIN
and
MAX
lines.
Step 6:
Once the level of the oil has been checked and
verified, press the START switch. The burners will
automatically turn back on and the fryer will resume heating.
verified, press the START switch. The burners will
automatically turn back on and the fryer will resume heating.