Sanyo MDF-593 Manual Do Utilizador

  3

 

 
 

 
 
 

Do not use the unit outdoors.    Current leakage or electric shock may result if the unit is exposed to 

rain water.

 

 

Only qualified engineers or service personnel should install the unit.  The installation by 

unqualified personnel may cause electric shock or fire. 

 

Install the unit on a sturdy floor.  If the floor is not strong enough or the installation site is not 

adequate, this may result in injury from the unit falling or tipping over.

 

Never install the unit in a humid place or a place where it is likely to be splashed by water.   

Deterioration of the insulation may result which could cause current leakage or electric shock.

 

Install a leak breaker on the power supply side when you use the unit in humid or wet situations, 

as well as installing an earth plate.    Consult our shops or an electrician for these installations.

 

Never install the unit in a flammable or volatile location. This may cause explosion or fire.

 

 

Never install the unit where acid or corrosive gases are present as current leakage or electric 

shock may result due to corrosion.

 

 

Use a dedicated power source is used as indicated on the rating label attached to the unit. 

 

 

Remove dust from the power supply plug before inserting in a power source.  A dusty plug or 

improper insertion may cause a hazard.

 

 

Use a power supply outlet with ground (earth) to prevent electric shock.  If the power supply 

outlet is not grounded, it will be necessary to install a ground by qualified engineers. 

 

Never ground the unit through a gas pipe, water main, telephone line or lightning rod.    Such 

grounding may cause electric shock in the case of an incomplete circuit. 

 

Never store volatile or flammable substances in this unit.    This may cause explosion or fire.

 

 

Never store corrosive substances in this unit.    This may lead to damage to the inner components 

or electric parts.

 

 

Disconnect the power supply to the unit prior to any repair or maintenance of the unit in order to 

prevent electric shock or injury.