Yamaha 006IPTO-F0 Manual Do Utilizador

Using the Solo Function

Control Room Monitoring

D

LISTEN
This parameter determines the source of the Input Channel Solo signal: Pre Fader or 
After Pan. When Pre Fader is selected, turning on the PAN button below the Pre Fader 
option will solo the channel with the pan position specified by the Pan setting even if the 
source precedes the fader. This parameter is effective only in Recording Solo mode.

E

SOLO TRIM
This parameter enables you to trim the level of the Solo signal in the range of –96 dB to 
+12 dB.

F

SOLO INTERRUPTION
When this parameter is set to Off, soloed channel signals are not fed to the Control 
Room Monitor outputs. To monitor the Control Room Monitor signals and soloed 
channel signals separately, change the output patching so that the soloed channel signals 
are output independently from the Control Room Monitor outputs, then turn the Solo 
Interruption parameter to Off.

G

SOLO SAFE CHANNEL
For Mixdown Solo mode, Input Channels can be configured individually so that they 
are not muted when other Input Channels are soloed (Solo Safe function). Signals from 
Input Channels with the SOLO SAFE CHANNEL button turned on are always fed to the 
Stereo bus, regardless of the channels’ Solo function status. You can clear all Solo Safe 
settings by turning on the ALL CLEAR button.

H

AUX/SOLO LINK
When this check box is checked, you can solo or unsolo Aux Sends using the AUX 
SELECT [AUX 1] - [AUX 8] buttons without having to switch to the Master layer (see 
page 107).

I

FADER/SOLO RELEASE
If this check box is checked, you can unsolo the channels by raising the channel faders 
that were at the level of –

∞ when the Solo function was turned on. If the faders were set 

to higher than –

∞, the channels cannot be soloed. This setting is not effective in Mix-

down Solo mode and for Output Channels.

You can solo and monitor Input Channels, Aux Out 1–8, and Bus Out 1–8 using the 
[SOLO] buttons on the top panel.

Set other parameters on the page, if necessary.