Yamaha 006IPTO-F0 Manual Do Utilizador
Punching In & Out
197
DM1000 Version 2—Owner’s Manual
Automix
16
Punching In & Out
You can modify part of a recorded Automix or add events to an Automix (Punch In & Out).
You can punch in and out channels using the [SEL] buttons, or individual parameters using
other controls.
You can punch in and out channels using the [SEL] buttons, or individual parameters using
other controls.
Punch In & Out Using the [SEL] Buttons
Follow the steps below to punch channels in and out using the [SEL] buttons.
1 Select parameters you wish to record in the OVERWRITE section.
2 Move the cursor to the REC or AUTO REC button at the bottom of the page,
then press [ENTER].
3 Press the [AUTO] button.
The button indicator lights up. At this time, make sure that the [SEL] button indicators for
all channels (including the channels you want to punch in) are lit green.
all channels (including the channels you want to punch in) are lit green.
4 Start the timecode source.
The REC and PLAY buttons are highlighted and parameter event recording is armed. How-
ever, no events are yet recorded since no channels are selected.
ever, no events are yet recorded since no channels are selected.
5 To punch in channels, press the corresponding [SEL] buttons.
The corresponding [SEL] button indicators light up red and the channels are placed in
record mode.
record mode.
6 Adjust the controls of the selected channels.
7 To punch out the channels, press the corresponding [SEL] buttons again.
8 Stop the Automix.
A confirmation window regarding updating the Automix data appears.
Punching In & Out Individual Events
Even if you selected some parameters in the OVERWRITE section, you can punch in an
individual parameter by following the steps below:
individual parameter by following the steps below:
1 In the OVERWRITE section, select the parameters you want to record.
2 Move the cursor to the REC or AUTO REC button at the bottom of the page,
then press [ENTER].
3 Press the [AUTO] button on the top panel.
The button indicator lights up. Make sure that the [SEL] button indicators for all channels
are lit green.
are lit green.
4 Start the timecode source.
The REC and PLAY buttons are highlighted and event recording is armed. However, no
events are yet recorded since no channels are selected.
events are yet recorded since no channels are selected.
Note: If the punch-in channels already contain the parameter events selected in the OVER-
WRITE section, punching-in immediately overwrites the existing events. Be careful while
selecting parameters in the OVERWRITE section so that you will not delete events you wish
to retain.
WRITE section, punching-in immediately overwrites the existing events. Be careful while
selecting parameters in the OVERWRITE section so that you will not delete events you wish
to retain.
Tip: You can also select the recording channels first using the [SEL] buttons, start the timecode
source, then select the desired parameters in the OVERWRITE section to punch in and out.
source, then select the desired parameters in the OVERWRITE section to punch in and out.