Yamaha 006IPTO-F0 Manual Do Utilizador

Machine Control Function

243

DM1000 Version 2—Owner’s Manual

Remote Control

3 Press the DISPLAY ACCESS [SETUP] button repeatedly until the Setup |

MIDI/Host page appears.

4 Move the cursor to either the MMC button or P2 button in the MACHINE

CONTROL section (

) to specify the remote control method, then press the

[ENTER] button.

In the MACHINE CONTROL section, you can also select the type of commands used on
the Remote | Machine Control page. The MMC button selects MMC commands, and the
P2 button select the P2 protocol.

5 If the MMC button is turned on, press the cursor [

] button to move the

cursor to the PORT parameter box, then rotate the Parameter wheel to select
the MMC destination.

The following ports and slots are available as the MMC destination.

• MIDI ..............................MIDI port

• USB ................................USB port

• SLOT1............................Slot 1 with an MY8-mLAN (mLAN card) installed

• REMOTE .......................REMOTE connector

If USB is selected, move the cursor to the adjacent parameter box (on the right), and select
one of eight ports.

6 Move the cursor to the DEVICE ID parameter box, then rotate the Parameter

wheel to set the DM1000 MMC Device ID to the same ID number as the exter-
nal device.

MMC commands are effective on devices that use the same Device ID. Therefore, the
DM1000’s MMC Device ID needs to match the ID of the devices you wish to control.