Yamaha 006IPTO-F0 Manual Do Utilizador

MIDI Port Setup

MIDI

• Rx PORT .......................This parameter specifies a port for general MIDI data recep-

tion. In the left parameter box, select MIDI, USB, SLOT1, or 
REMOTE. If you select USB, specify the port number in the 
right parameter box.

• Tx PORT........................This parameter specifies a port for general MIDI data transmis-

sion. The available ports are the same as for the Rx PORT 
parameter.

B

MIDI THRU section
These parameters enable you to route incoming MIDI data from one port to another 
without changes. Select a port for reception in the first parameter box, and select a port 
for transmission in the next parameter box (located to the right of the arrow). If you 
select USB, specify the port number in the small parameter box adjacent to the port 
parameter box.

C

MACHINE CONTROL section
This section enables you to select a remote control method and a remote control port to 
control external devices, including hard disk recorders and video equipment.

• TYPE..............................Specify a type (method) of remote control by turning on either 

the MMC (MIDI Machine Control) button or the P2 (Sony P2 
protocol) button.

• PORT .............................Select MIDI, USB, SLOT1, or REMOTE for MMC command 

transfer. If you select USB, specify the port number in the right 
parameter box.

• DEVICE ID ...................Specify the DM1000’s MMC Device ID. MMC Device IDs 

identify connected devices, enabling recognition during MMC 
transmission and reception.

D

SPECIAL FUNCTIONS section
This section enables you to specify ports for various special functions.

• Studio Manager............In the left parameter box, select MIDI, USB, SLOT1, or 

REMOTE as the port used by the included Studio Manager 
software. In the two small parameter boxes on the right, specify 
a port number (if you selected USB), and an ID number.

• DAW...............................Select USB or SLOT1 as a port for use with a DAW. If you select 

USB, specify in the right parameter box a port number pair 
(1-3, 2-4, 3-5, 4-6, 5-7, 6-8).

• REMOTE 1 ....................This parameter indicates the target currently selected for 

Remote Layer 1. If the target is set to “USER DEFINED,” you 
can select a MIDI message destination port.

• REMOTE 2 ....................This parameter indicates the target currently selected for 

Remote Layer 2. If the target is set to “USER DEFINED,” you 
can select a MIDI message destination port.

• CASCADE LINK ..........Select MIDI or REMOTE as a port for DM1000 cascade con-

nection. The TRANSMIT and REQUEST buttons are used to 
synchronize all parameters that are cascade-linked. The 
TRANSMIT button synchronizes the connected DM1000’s 
parameters to your primary DM1000’s parameters. The 
REQUEST button synchronizes your DM1000 parameters to 
the connected DM1000’s parameters.