Yamaha 006IPTO-F0 Manual Do Utilizador
Assigning Parameters to the ENCODER MODE [ASSIGN] button
37
DM1000 Version 2—Owner’s Manual
3
Operating Basics
Assigning Parameters to the ENCODER MODE [ASSIGN]
button
button
While the ENCODER MODE [ASSIGN] button indicator is lit, you can use Encoders 1–16
to control a parameter assigned to the [ASSIGN] button. Follow the steps below to assign a
parameter to the [ASSIGN] button.
to control a parameter assigned to the [ASSIGN] button. Follow the steps below to assign a
parameter to the [ASSIGN] button.
1 Press the ENCODER MODE [DISPLAY] button.
The Encoder | Encoder page appears. The name of the parameter currently assigned to the
[ASSIGN] button is displayed in the left-hand box. All assignable parameters are displayed
in the right-hand box. (The parameter currently-assigned to the button is highlighted in the
right-hand box.)
[ASSIGN] button is displayed in the left-hand box. All assignable parameters are displayed
in the right-hand box. (The parameter currently-assigned to the button is highlighted in the
right-hand box.)
2 Use the Parameter wheel or press the [INC]/[DEC] buttons to select a param-
eter in the right-hand box.
A parameter is selected when it appears inside the dotted box. Refer to the next page for a
complete list of assignable parameters.
complete list of assignable parameters.
3 Press [ENTER] to confirm the assignment.
Once assigned, press the ENCODER MODE [ASSIGN] button to turn on the button indi-
cator. You can now use Encoders 1–16 to control the assigned parameter.
cator. You can now use Encoders 1–16 to control the assigned parameter.
Note: When channels that do not feature the currently-assigned parameter are selected, the
Encoders are inactive. For example, if the assigned Encoder parameter is “Phase,” and the Mas-
ter layer is selected, Encoders are inactive, because the Aux Sends and Bus Outs do not feature
Phase parameters.
Encoders are inactive. For example, if the assigned Encoder parameter is “Phase,” and the Mas-
ter layer is selected, Encoders are inactive, because the Aux Sends and Bus Outs do not feature
Phase parameters.