Yamaha 006IPTO-F0 Manual Do Utilizador
Setting the Input Channels from the Control Surface
75
DM1000 Version 2—Owner’s Manual
6
Input Channels
Setting the Input Channels from the Control Surface
You can use the faders, Encoders, [SEL] buttons, and various buttons and controls in the
SELECTED CHANNEL section on the top panel to directly control most parameters for
Input Channels.
SELECTED CHANNEL section on the top panel to directly control most parameters for
Input Channels.
Setting Input Channel Levels and Panning the Channels
1 Press the LAYER [1-16], [17-32], or [33-48] button to select a Layer.
2 Use the faders to set the Input Channel levels.
3 Press the ENCODER MODE [PAN] button, then rotate the corresponding
Encoder to pan the desired Input Channel.
When you rotate the Encoder, the current pan setting display pops up.
Routing and EQ’ing Input Channels
1 Press the [SEL] button or move the fader for the channel you wish to control.
2 To route each Input Channel, use the following buttons in the SELECTED
CHANNEL section:
• ROUTING [1]–[8] buttons ............... These buttons route the currently-selected Input
Channel to a Bus.
• ROUTING [STEREO] button ........... When this button is turned on, Input Channel
signals are routed to the Stereo Bus.
• ROUTING [DIRECT] button ........... When this button is turned on, the cur-
rently-selected Input Channel is routed to its
Direct Out. (See page 115 for more information
on Direct Out.)
Direct Out. (See page 115 for more information
on Direct Out.)
The corresponding button indicator lights up.
3 To control EQ for the currently-selected channel, press one of the following
buttons to select the band you wish to adjust:
• EQUALIZER [HIGH] button............ HIGH band
• EQUALIZER [H-MID] button.......... HIGH-MID band
• EQUALIZER [L-MID] button........... LOW-MID band
• EQUALIZER [LOW] button.............. LOW band