Beko BZ 77F Manual Do Utilizador

Página de 36
EN
25
4  
Before operating 
Starting
Final Check
Before you start using the refrigerator 
check that:
1.The  front feet have been adjusted 
so the appliance is level.
2.The interior is dry and air can 
circulate freely at the rear.
3.Clean the interior as recommended 
under “CLEANING AND CARE.”
4.Insert the plug into the wall socket 
and switch on the electricity supply.  
Avoid accidental disconnection by 
taping over the switch. Green light will
glow and the compressor will start 
running in about five minutes.
5.You will hear a noise as the 
compressor starts up. The liquid and 
gases sealed  within the refrigeration 
system may also give rise to noise, 
whether the compressor is running or 
not which is quite normal.
 6.We recommend that you set the 
thermostat halfway between Min. and 
Max. (See section Temperature Control 
and Adjustment).
7.Do not load the appliance 
immediately it is switched on. Wait 
until the correct storage temperature 
has been reached. We recommend 
that you check the temperature 
with an accurate thermometer (see; 
Temperature Control and Adjustment)
1.If there is a power failure do not open 
the door. Frozen food should not be
 affected if the failure lasts for less than 
11 hours. If the failure is longer, then  
the food should be checked and either 
eaten immediately or cooked and  
then re-frozen.
2.If you find the freezer door difficult 
to open just after you have closed it, 
don’t worry. This is due to the pressure 
difference which will equalise and  
allow the door to open normally after a 
few moments.
3.You will hear a vacuum sound just 
after closing the door. This is quite  
normal.
4. When you switch on, the appliance 
will not start immediately, because the  
appliance incorporates a protection 
device in the electronics - wait for 
about   5 minutes.