Whirlpool 8910 Manual Do Utilizador

EN4

After unpacking the oven, make sure that it has not been damaged during transport and that the oven 
door closes properly. In the event of problems, contact the dealer or your nearest After-sales Service. 
To prevent any damage, only remove the oven from its polystyrene foam base at the time of installation.
To safely move the oven, use the handle provided in the accessories pack.
1.

Insert the handle securely into the lateral holes (Fig. 1)

2.

Lift the handle up as shown in Fig. 2

•

Kitchen units in contact with the oven must be heat resistant (min 90°C).

•

Carry out all cabinet cutting work before fitting the oven in the housing and carefully remove all 
wood chips and sawdust.

•

After installation, the bottom of the oven must no longer be accessible.

•

For correct appliance operation, do not obstruct the minimum gap between the worktop and the 
upper edge of the oven.

Make sure the power voltage specified on the appliance dataplate is the same as the mains voltage. 
The dataplate is on the front edge of the oven (visible when the door is open).
•

Power cable replacement (type H05 RR-F 3 x 1.5 mm

2

) must be carried out by a qualified electrician. 

Contact an authorized service centre.

•

The oven is programmed to operate with power absorption above 2.5 kW (indicated by "HIGH" in the 
settings) which is compatible with a domestic power supply above 3kW. If the household has a lower 
power supply, the setting must be lowered ("LOW" in the settings). The table below details the 
recommended electrical power settings for the various countries.

Fig. 1 Fig. 2 

Germany

High

Spain

Low

Finland

High

France

High

Italy

Low

Holland

High

Norway

High

Sweden

High

UK

Low

Belgium

High