Yamaha DM2000 Manual Do Utilizador

Routing Input Channels

You can also control the parameters from the channel strips on the control surface as 
described below by using the User Assignable Layer of the Remote Layers. See page 269 for 
information on the User Assignable Layer.

Encoders: The Encoders are not available.
[AUTO] buttons: These buttons are used to control the Fader Group Master On/Off and 
the master level during Automix.

[SEL] buttons: These buttons move the cursor on the Input Fader Group Master page.
[SOLO] buttons: These buttons turn the Solo function of each Fader group on and off. 
You can monitor all the channels in each Fader group.

Channel Strip Displays: The displays indicate the Group names (GrpA – GrpH). When 
you operate the channel faders, the displays indicate the corresponding master level values.

Channel Faders: The channel faders enable you to set the master level for each Fader 
group.

Each Input Channel can be routed to the Bus Outs, Stereo Out, or its own Direct Out.

Use the [1–8], [STEREO], and [DIRECT] buttons to route the 
currently selected Input Channel.
[1–8]: These buttons route the currently selected Input Channel to the 
Bus Outs.

[STEREO]: This button routes the currently selected Input Channel to 
the Stereo Out.

DIRECT: This button routes the currently selected Input Channel to its Direct Out.
[FOLLOW PAN]: This determines whether the Input Channel’s Pan control setting is 
applied to the Bus Outs. When off, the levels of the signals fed to the odd and even Bus Outs 
is the same. When on, the levels of the signals fed to the odd and even Bus Outs follows the 
Pan control.

In Surround mode, when this button is turned off, the surround pan setting does not affect 
signals fed to the Bus Outs. You can enable the surround pan setting when the input source 
is monaural, and patch the surround sources or surround effects directly to the Surround 
Buses.