Alpine 68-14470Z98-A Manual Do Utilizador

01GB03CDE103BT.fm

ALPINE CDE-103BT 68-14470Z98-A (EN)

Do not grip or pull out the disc while it is being pulled back into the 
player by the automatic reloading mechanism.
Do not attempt to insert a disc into the unit when the unit power is 
off.

Your player accepts only one disc at a time for playback. Do not 
attempt to load more than one disc.
Make sure the label side is facing up when you insert the disc. 
“ERROR” will be displayed on your player if you insert a disc 
incorrectly. If “ERROR” continues to be displayed even though the 
disc has been inserted correctly, push the RESET switch with a 
pointed object such as a ballpoint pen.
Playing a disc while driving on a very bumpy road may result in 
skips, but this will not scratch the disc or damage the player.

To prevent the CD from jamming, “ERROR” is displayed if discs 
with irregular surfaces are inserted or if discs are inserted 
incorrectly. When a new disc is ejected immediately after initial 
loading, use your finger to feel around the inside of the center hole 
and outside edge of the disc. If you feel any small bumps or 
irregularities, this could inhibit proper loading of the disc. To 
remove the bumps, rub the inside edge of the hole and outside edge 
of the disc with a ballpoint pen or other such instrument, then insert 
the disc again.

Be sure to use round shape discs only for this unit and never use 
any special shape discs.
Use of special shape discs may cause damage to the mechanism.

Make sure this unit will not be installed in a location subjected to:

• Direct sun and heat
• High humidity and water
• Excessive dust
• Excessive vibrations

Do not drop the disc while handling. Hold the disc so you will not 
leave fingerprints on the surface. Do not affix tape, paper, or 
gummed labels to the disc. Do not write on the disc.

Fingerprints, dust, or soil on the surface of the disc could cause the 
CD player to skip. For routine cleaning, wipe the playing surface 
with a clean, soft cloth from the center of the disc to the outer edge. 
If the surface is heavily soiled, dampen a clean, soft cloth in a 
solution of mild neutral detergent before cleaning the disc.

There are various accessories available on the market for protecting 
the disc surface and improving sound quality. However, most of 
them will influence the thickness and/or diameter of the disc. Using 
such accessories can cause the disc to be out of standard 
specifications and may create operational problems. We 
recommend not using these accessories on discs played in Alpine 
CD players.

01GB00CDE103BT.book  Page 4  Thursday, June 25, 2009  1:48 PM