Bakers Pride CSWG Manual Do Utilizador

 
The Default Screen appears on the touchscreen during normal 
operation.  The screen shows the menu button and a 
representive temperature. 
 
The representative temperature does not correspond to the 
internal temperature of the food products in the case.  This 
temperature is only an indication that the case is operating 
properly and heating. 
 
When the unit is first powered up the representative temperature 
will be approximately room temperature.  As the unit preheats the 
representative temperature will rise.  The representative 
temperature will stabilize when the unit reaches operating 
temperature. 
 
The representative temperature should be approximately the 
same from day to day when the unit is in operation.  A significant 
change in this temperature without changing any of the 
temperature settings of the unit may indicate a problem with the 
unit.  A qualified BKI service representative should be contacted. 
 

 
 
 

 

 

 
The current heater settings can be viewed by touching the Menu 
Button [M] on the Default Screen.   The Menu Screen will then be 
displayed.   
 
To view the current settings for either Well Temp or Upper Heater 
touch the appropriate button on the Menu Screen. The View 
Setting Screen for the selected heaters will be displayed. 
 
To return to the Default Screen, touch the Exit Button [X]. 
 
If the controller is configured to control each well position 
independently the View Setting Screen as shown at right will be 
displayed.  Use the left and right arrows to display the heater 
setting for the various well positions of the unit.  The progress bar 
gives a visual representation of the well location for which the 
setting is being displayed. 
 
The current heater setting is displayed on the right side of the 
screen.  The setting is a numeric value between 1 and 10 where 
10 is the hottest setting. 
 
If the controller is configured to control all of the well positions at 
the same setting, the progress bar will be solid and the left and 
right arrows will not be displayed.   The setting shown will be for 
the heaters at all of the well positions. 
 
To return to the Menu Screen, touch the Menu Button [M].  To 
return to the Default Screen, touch the Exit Button [X]. 
 
Touching [Set Clock] on the Menu Screen will display the time 
and date. To return to the Menu Screen, touch the Menu Button 
[M].  To return to the Default Screen, touch the Exit Button [X]. 

 
 
 

 

 

 

 

Lower Right 

Lower Left 

Menu Button 

Exit Button 

Progress Bar 

Current Setting