Frigidaire 318201822 Instrução De Instalação
WARMER DRAWER INSTALLATION INSTRUCTIONS
1
D
A
B
F
E
C
FLOOR
Warmer Drawer
Cutout
Cutout
Warmer Drawer
60" (152,4 cm)
Cord
Minimum distance to
floor 4½" (11,4 cm)
floor 4½" (11,4 cm)
GENERAL INFORMATION - The Warmer Drawer can
be used as a stand alone appliance or as a combination
Warmer Drawer with a built-in oven mounted above.
be used as a stand alone appliance or as a combination
Warmer Drawer with a built-in oven mounted above.
P/N 318201822 (0901) Rev. A
English – pages 1-4
Español – páginas 5-8
Français – pages 9-12
Warmer Drawer Dimensions
NOTE: A 60" (152,4 cm) long cable is supplied with
the Warmer Drawer.
the Warmer Drawer.
Stand Alone Installation
* Note: It is also possible to install this warmer drawer in a height opening
of 9¼" (23,5 cm). Please refer to page 3 for complete instructions.
of 9¼" (23,5 cm). Please refer to page 3 for complete instructions.
Printed in United States
IMPORTANT: The Warmer Drawer runs off a single
phase three-wire 120 volt, 60 hertz, AC only electrical
supply with ground.
phase three-wire 120 volt, 60 hertz, AC only electrical
supply with ground.
Combination Warmer Drawer / 27" (68,6 cm) or
30" (76,2 cm) Built-in Oven Installation
H* =11
7
/
8
" (30,2 cm) Min. is the space between the
bottom of the drawer cutout and the bottom of the
Bottom of oven cutout
Caution: Two 3" (7,6 cm) wide X
¾" (1,9 cm) thick planks have to be
installed and they should be able to
support 200 pounds (90,7 Kg).
¾" (1,9 cm) thick planks have to be
installed and they should be able to
support 200 pounds (90,7 Kg).
29
1
/
16
"
(73,8 cm)
A. HEIGHT
B. WIDTH
C. DEPTH
27" Models
11 ¼" (28,6 cm)
27" (68,6 cm)
23
3
/
8
" (59,4 cm)
30" Models
11 ¼" (28,6 cm)
30" (76,2 cm)
23
3
/
8
" (59,4 cm)
D. CUTOUT
HEIGHT
E. CUTOUT
WIDTH
F. CUTOUT
DEPTH
27" Models - Min. 9
7
/
8
" (25,1 cm) 25 ½" (64,8 cm)
23
5
/
8
" (60 cm)
Max.
10 ¼" (26 cm)
25 ¾" (65,4 cm)
24" (61 cm)
30" Models - Min. 9
7
/
8
" (25,1 cm) 28 ½" (72,4 cm) 23
5
/
8
" (60 cm)
Max.
10 ¼" (26 cm)
28 ¾" (73 cm)
24" (61 cm)
A. HEIGHT
B. WIDTH
C. DEPTH
27" Models 11 ¼" (28,6 cm)
27" (68,6 cm)
23
3
/
8
" (59,4 cm)
30" Models 11 ¼" (28,6 cm)
30" (76,2 cm)
23
3
/
8
" (59,4 cm)
D. CUTOUT
HEIGHT
E. CUTOUT
WIDTH
F. CUTOUT
DEPTH
G. HEIGHT
27" - Min.
9
7
/
8
" (25,1 cm)
25 ½" (64,8 cm) 23
5
/
8
" (60 cm)
2" (5,1 cm)
Max. 10 ¼" (26 cm)
25 ¾" (65.4 cm)
24" (61 cm)
Depends on critical
dimension H
30" - Min.
9
7
/
8
" (25,1 cm)
28 ½" (72,4 cm) 23
5
/
8
" (60 cm)
2" (5,1 cm)
Max. 10 ¼" (26 cm)
28 ¾" (73 cm)
24" (61 cm)
Depends on critical
dimension H
INSTALLATION AND SERVICE MUST BE PERFORMED
BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
WARNING
FOR YOUR SAFETY: Do not store or use gasoline or other
flammable vapors and liquids in the vicinity of this or any other appliance.
Canada
United States
IMPORTANT: The warmer drawer must be installed on a
surface leveled from left to right, rear to front and the surface
must be capable of supporting 100 pounds (45,4 Kg).
surface leveled from left to right, rear to front and the surface
must be capable of supporting 100 pounds (45,4 Kg).
oven cutout. This is a critical dimension and must be provided.
J** = 3" (7,6 cm) Max. Electrical Junction Box for wall oven can be
lower than warmer drawer cutout.
J** = 3" (7,6 cm) Max. Electrical Junction Box for wall oven can be
lower than warmer drawer cutout.