Snapper RP217017BV Manual Do Utilizador

 

2.  Remove driven disc spring from driven disc 
assembly. Loosen connector hex nut. See Figure 
4.9. 

 

 

 

 
3. Slide driven disc assembly over to 1/8” from 
outside edge of drive disc. Maintaining the 1/8” 
measurement, remove any looseness from the 
linkage.  This can be done by holding the transfer 
rod and applying pressure to the left (as viewed 
from operators position). Then retighten the 
connector hex nut securely. See Figure 4.10. Move 
ground speed control to the first speed position, 
then back to the sixth speed position. Recheck the 
1/8” measurement described previously.  Reinstall 
driven disc spring to driven disc assembly. 

 

4.3.4.  Replacing Rubber Driven Disc 
If the rubber is badly chunked or worn it must be 
replaced. Install new Driven Disc as follows: 
1.  Using a small flat blade screwdriver, free the clip 
from the transfer rod. Then remove the transfer rod 
from the clip and the speed control rod. See Figure 
4.11.