Snapper RP217017BV Manual Do Utilizador
8
Section 2 - OPERATING INSTRUCTIONS
2.4 HANDLE HEIGHT ADJUSTMENT
The height of the mower handle can be adjusted as
follows:
1. Loosen the lower nuts on each lower handle as
shown in Figure 2.8.
follows:
1. Loosen the lower nuts on each lower handle as
shown in Figure 2.8.
FIGURE 2.8
2. Move upper mower handle up or down until the
desired position is achieved.
3. Tighten the lower nuts on each lower handle to
maintain desired position.
desired position is achieved.
3. Tighten the lower nuts on each lower handle to
maintain desired position.
WARNING
Stop engine and mower blade by releasing the blade
control before adjusting cutting height.
control before adjusting cutting height.
2.5 CUTTING HEIGHT ADJUSTMENT
1. Pull the height adjusting latch outward and move
to desired cutting height. See Figure 2.9.
to desired cutting height. See Figure 2.9.
FIGURE 2.9
2.5 CUTTING HEIGHT ADJUSTMENT
2. Set all wheels at the same cutting height. The
highest cutting position is Notch 6. The lowest
cutting position is Notch 1. See Figure 2.10.
highest cutting position is Notch 6. The lowest
cutting position is Notch 1. See Figure 2.10.
FIGURE 2.10
HIGHER
LOWER
LOOSEN LOWER
NUTS ON EACH
LOWER HANDLE
NUTS ON EACH
LOWER HANDLE
LOWER
HANDLE
HANDLE
LATCH
POSITIONS
POSITIONS
CUTTING HEIGHT SETTINGS
LOWEST CUTTING
HEIGHT
HEIGHT
1
LATCH
HIGHEST
CUTTING
HEIGHT
CUTTING
HEIGHT
6
2
1
3
4
5
6