Samsung RSG307AABP Manual Do Utilizador

Página de 64
operating
 
_17
02 OPERA
TING
CHANGING THE WATER FILTER
To reduce risk of water damage to your 
property DO NOT use generic brands of 
water fi lers in your SAMSUNG Refrigerator. 
USE ONLY SAMSUNG BRAND WATER 
FILTERS.
SAMSUNG is not legally responsible for any damage, 
including, but not limited to property damage caused 
by water leakage from the use of a generic water fi lter.
SAMSUNG Refrigerators are designed to work ONLY 
WITH SAMSUNG Water Filters.
The “Filter Indicator” light lets you know when it is 
time to change your water fi lter cartridge. To give you 
preparation time to get a new fi lter, the red light will 
come on just before the capacity of the current fi lter 
runs out. Changing the fi lter on time provides you with 
the freshest, cleanest water from your fridge.
To change the water fi lter, follow these steps:
1.  Turn the water fi lter 90˚ 
counter-clockwise.
2.  Pull the water fi lter from the 
fi lter housing.
3.  Insert new water fi lter inside 
the fi lter housing.
4.  Turn the new water fi lter 90˚ 
clockwise.
5.  Press the “Alarm/hold 3 sec for Filter Reset” 
button ( 
 ) for about 3 seconds to reset the 
water fi lter. The color of indicator changes from red 
to light off.
A newly installed water fi lter cartridge may 
cause water to briefl y spurt from the water 
dispenser. This is due to air getting into the 
line. It should pose no problem to operation.
Removing residual matter inside the water 
supply line after installing a new fi lter
1.  Press the Water button, and then push the 
Dispenser Lever with a cup or glass.
2.  Flush 1 gallon of water through the fi lter, one 
cup or glass at a time.  (Flush approximately 6 
minutes.) This will clean the water supply system 
and remove air from the lines.
 -  Additional fl ushing may be required in some 
households.
3.  Open the refrigerator door and make sure there 
are no water leaks coming from the water fi lter.
Reverse Osmosis Water Supply
IMPORTANT : The pressure of the water supply 
coming out of a reverse osmosis system going to 
the water inlet valve of the refrigerator needs to be 
between 35 and 120 psi (241 and 827 kPa).
If a reverse osmosis water fi ltration system is 
connected to your cold water supply, the water 
pressure to the reverse osmosis system needs to be a 
minimum of 40 to 60 psi (276 to 414 kPa.)
If the water pressure to the reverse osmosis system is 
less than 40 to 60 psi (276 to 414 kPa):
•  Check to see whether the sediment fi lter in the 
reverse osmosis system is blocked. Replace the 
fi lter if necessary.
•  Allow the storage tank on the reverse osmosis 
system to refi ll after heavy usage.
•  If your refrigerator has a water fi lter, it may 
further reduce the water pressure when used 
in conjunction with a reverse osmosis system. 
Remove the water fi lter.
If you have questions about your water pressure, call a 
licensed, qualifi ed plumber.
Ordering replacement fi lters
To order more water fi lter cartridges, contact your 
authorized Samsung dealer.
WARNING
DA68-02500A.indb   17
DA68-02500A.indb   17
2012.5.16   2:52:23 PM
2012.5.16   2:52:23 PM