KitchenAid 12828154 Manual Do Utilizador

Depending on your model, your refrigerator may have two 
(Style 1) or four (Style 2) adjustable rollers located at the base of 
the refrigerator. If your refrigerator seems unsteady or you want 
the door to close easier, adjust the refrigerator's tilt using the 
instructions below. 

1. Remove the base grille. Grasp the grille firmly and pull it 

toward you.

2. Using a screwdriver or 

³⁄₈" hex driver, turn the roller 

adjustment screw(s) on each side to raise or lower that side of 
the refrigerator.

NOTE: Having someone push against the top of the 
refrigerator takes some weight off the adjustment screws and 
rollers. This makes it easier to turn the screws.

■

To raise, turn the roller adjustment screw to the right.

■

To lower, turn the roller adjustment screw to the left.

NOTE: It may take several turns of the roller adjustment 
screw to adjust the tilt of the refrigerator.

3. Open the door again to make sure that it closes as easily as 

you like. If not, tilt the refrigerator slightly more to the rear by 
turning both front adjustment screws to the right. It may take 
several more turns, and you should turn both adjustment 
screws the same amount.

4. Lower the stabilizing foot by turning it clockwise until it is 

firmly against floor.

5. Turn the front adjustment screws counterclockwise to allow 

the full weight of the refrigerator to rest on the stabilizing feet.

6. Replace the base grille.

Please read before using the water system.

Immediately after installation, follow the steps below to make 
sure that the water system is properly flushed.

1. Turn off the ice maker by opening the freezer door and lifting 

up the wire shutoff arm as shown.

2. Install the interior water filter. The interior water filter mounting 

bracket is located on the left side wall of the refrigerator 
compartment. 

■

Remove blue bypass cap and retain for later use.

■

Remove the interior water filter from its packaging. 
Remove the sealing label from the end of the filter and 
insert it into the filter head.

■

Gently rotate the filter clockwise until it stops. Then snap 
the filter cover closed.

3. Flush the water system by dispensing and discarding 2 to 

3 gal. (8 to 12 L) of water. Flushing the system will take 
approximately 6 to 7 minutes and will help clear air from the 
line. Additional flushing may be required in some households.

NOTE: As air is cleared from the system, water may spurt out 
of the dispenser.

4. Inspect the filter system for water leaks. If you see water 

leaks, see the “Troubleshooting” section.

5. Turn on the ice maker by opening the freezer door and 

lowering the wire shutoff arm as shown.

 

Please refer to the 

“Ice Maker” section for further instructions on the operation 
of your ice maker.

■

Allow 24 hours to produce the first batch of ice. 

■

Discard the first three batches of ice produced. 

A

B

A B

A

B

C

C

Do not use with water that is microbiologically unsafe or 
of unknown quality without adequate disinfection before 
or after the system. Systems certified for cyst reduction 
may be used on disinfected waters that may contain 
filterable cysts.