Gigaset AL140 Duo L36852-H2001-M101 Manual Do Utilizador
Códigos do produto
L36852-H2001-M101
9
L1a / GBR / A31008-M2001-L101-1-7619 / AL140_AL145_Kombi_GBR.fm / 12.09.2008
Base station power consumption
General specifications
Care
Wipe the base station, charging cradle and hand-
set with a damp cloth (do not use solvent) or an
antistatic cloth.
Never use a dry cloth. This can cause static.
Never use a dry cloth. This can cause static.
Contact with liquid
If the handset has come into contact with liquid:
1. Switch off the handset and remove the bat-
1. Switch off the handset and remove the bat-
tery pack immediately.
2. Allow the liquid to drain from the handset.
3. Pat all parts dry, then place the handset with
3. Pat all parts dry, then place the handset with
the battery compartment open and the keypad
facing down in a dry, warm place for at least
72 hours (not in a microwave, oven etc.).
4. Do not switch on the handset again until it is
completely dry.
When it has fully dried out, you will normally be
able to use it again.
Questions and answers
If you have any questions about using your phone,
visit us at www.gigaset.com/customercare at any
time. The table below contains a list of common
problems and possible solutions.
AL140
AL145
In standby mode
– Handset in charging cradle
– Handset out of charging cradle
approx.
1.0 W
approx.
0.8 W
approx.
1.2 W
approx.
1.0 W
During a call
approx.
1.0 W
approx.
1.2 W
DECT standard
is supported
GAP standard
is supported
Range
up to 300 m outdoors
up to 50 m indoors
Base station power supply
230 V ~/50 Hz
Environmental conditions
in operation
+5° C to +45 °C;
20% to 75% humidity
!
Problem
Cause
Solution
Nothing
appears in
the display.
The handset is not
turned on.
Battery pack is
flat.
Press the end call key
a
for approx. 5 sec-
onds or place the
handset in the base
station.
Charge/replace the
battery pack (page 3).
No reaction
to key press.
The keypad lock is
activated.
Press the hash key
R
for approx. 2 sec-
onds (page 1).
No wireless
connection to
the base sta-
tion, Base
flashes in
the display.
The handset is
outside the range
of the base sta-
tion.
The handset is not
registered.
The base station is
not turned on.
Cords not routed
correctly.
Move the handset
closer to the base
station.
Register the handset
Check the power con-
nector at the base sta-
tion (page 2).
Check cord routing
You cannot
hear a ringer/
dialling tone
from the fixed
network.
The phone cord
supplied has not
been used or has
been replaced by
a new cord with
the wrong jack
connections.
Please always use the
phone cord supplied
or ensure that the jack
connections are cor-
rect when purchasing
from a retailer
Error tone
sounds after
system PIN
prompt.
PIN forgotten.
You have entered
the wrong system
PIN.
Reset the system PIN
to the default 0000.
To do this, unplug the
mains unit from the
mains socket
£
Press and hold the
paging key
£
Plug the mains
adapter in again
£
Hold the paging
key down for at least
another 2 seconds
and then release.
The reset procedure is
now carried out.
The handsets are de-
registered. The calls
list is cleared.