Dacor DYF428IWS Manual Do Utilizador

5.  Using the two screws, attach the base grille assembly to the 

refrigerator as shown. 

NOTE: Drive in the right side screw first.

4.  Trim the skirt by scoring the 

proper “V” groove with a utility 
knife. Break the skirt at the 
score line.

3.  Snap the skirt onto the base grille.

Install Side Panel(s)

If the built-in area depth is 25” (63.5 cm) or more, the side panels 
can be installed inside the side trim or attached to the outside of 
the side trim.

IMPORTANT: Dacor is not responsible for customer installed 
molding or decorative panels that need to be removed or replaced 
to service the refrigerator.

1.  For the inside side trim piece, slide the front edge of the 

routed side panel into the trim piece.

2.  Nail the rear edge of the panel to the support board.

Install Base Grille

There are two pieces to the base grille to allow for a custom fit: 
the base grille itself and the skirt. The skirt can be added to the 
base grille in order to extend it all the way to the floor.

1.  To see if the skirt is needed, place the base grille into position. 

Do not attach the base grille to the refrigerator. Measure the 
distance between the bottom of the base grille and the floor. 
The gap must be a minimum of ½” (1.3 cm) in order to add the 
skirt.

NOTE: If the gap measures less than ½” (1.3 cm), skip steps 3 
and 4 of the instructions, and install the base grille only.

2.  Remove the film from the base grille.

Installation Instructions